Dfrobot SEN0161-V2 SEN0161-V2 PH Sensor / Meter Kit V2 Gravity Analogue Arduino/micro:bit/Raspberry Pi Boards(Dfrobot Sen0161 V2 Sen0161 V2 Ph Sensor Meter Kit V2 Gravity Analogue Arduino Micro Bit Raspberry Pi Boards)

Gravity: Analog pH sensor/meter kit V2 is specifically designed to measure the pH of the solution and reflect the acidity or alkalinity. It is commonly used in various applications such as aquaponics, aquaculture, and environmental water testing.

• 3.3V to 5.5V wide voltage input
• Hardware filtered output signal, low jitter
• Gravity connector and BNC connector, plug and play, no welding
• Software library supports 2-point calibration and automatically identifies standard buffer solution
• Uniform size and connector, convenient for the design of mechanical structures

Contents

PH probe(laboratory grade) x 1, pH signal conversion board x1, Gravity analogue sensor cable x 1, pH standard buffer solution 4.0 x2, pH standard buffer solution 7.0 x 2, Waterproof gasket x 2, Screw cap for BNC connector x 1, M3 x 10 nylon pillar x 4, M3 x 5 screws x 8.

Product details

Accessory Type	Gravity Analogue pH Sensor / Meter Kit V2
For Use With	Arduino, micro:bit and Raspberry Pi Boards
Product Range	–

Other details

Brand	DFROBOT
Part Number	SEN0161-V2
Quantity	1 Kit
Technical Data Sheet EN

All product and company names are trademarks™ or registered® trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.